Oramask 831 topcoat spraypaint problems - Shapeoko - Carbide 3D

I recently carved a squadron badge for a friend and it was my 1st time using the method of paint then lay down vinyl then carve then paint the carved area then peel the vinyl. I used Oracal 631, I was very pleased with the way that it carved. I used a quarter inch down cut bit an 8th inch down cut followed by a 60ﾟ V bit and it cut beautifully. I had spray painted white then carved it then I spray painted black on top of the vinyl and carved areas, I sprayed 3 Coats of Rest oleum 2X satin spr

ORAMASK 813 Paint Mask Stencil 3mil, Adhesive Water-Based - 15 x 50YD Roll (Punched)

My Carbide 3D

My Carbide 3D

Carbide Office Hours #13 - How to Troubleshoot Common Problems

Cash Only Signage - Gallery - Carbide 3D Community Site

Rust-Oleum® Inverted Marking Paint - Orange S-21641O - Uline

Ridges on pieces - Shapeoko - Carbide 3D Community Site

Aluminum Machining Marks - Shapeoko - Carbide 3D Community Site

Carbide Motion Probing Problems with on screen instructions - Carbide Motion - Carbide 3D Community Site

Help with proper bit selection - Shapeoko - Carbide 3D Community Site

My Carbide 3D