Can't cut all the way through 3mm basswood (likely user error) - LightBurn Software Questions - LightBurn Software Forum

I’m guessing I am doing something wrong here. I have a Gweike Cloud 50 watt laser. From what I have read, the model I have (newest release) is more powerful then previous releases (which were good cutters). I import the outline of a shape into Lightburn as a png. I “traced” it into a vector. Even setting 100% power at a slow rate, it does not go all the way through 3mm basswood. The attached image shows the back of the cut. What could make it do this instead of cutting through? The resul

Can't cut all the way through 3mm basswood (likely user error) - LightBurn Software Questions - LightBurn Software Forum

Ortur Master 3 error message - LightBurn Software Questions - LightBurn Software Forum

Struggling with a cut on 3mm Birch - Tips and Tricks - LightBurn Software Forum

Material test problem - LightBurn Software Questions - LightBurn Software Forum

Cutting 3mm plywood - Common Problems - LightBurn Software Forum

How do I convert a PDF to a cut file - #14 by Marcus_Wakefield - LightBurn Software Questions - LightBurn Software Forum

How to use Gweike Cloud with LightBurn + tips, tricks & FAQ - Gweike & Gweike Cloud - LightBurn Software Forum

Problem with tabs - LightBurn Software Questions - LightBurn Software Forum

Laser Is Not Cutting Through The Entire Project - Ortur Lasers - LightBurn Software Forum

Gweike Cloud Laser Cutter & Engraver with Rotary CO2 (50W) Pro II – gweike cloud

Laser cuts through project while creating an array - BUG? - LightBurn Software Questions - LightBurn Software Forum

Can't trace file - LightBurn Software Questions - LightBurn Software Forum

Struggling with a cut on 3mm Birch - Tips and Tricks - LightBurn Software Forum