Shellac bubbles when drying - Finishing - Carbide 3D Community Site
By A Mystery Man Writer
Last updated 16 Aug 2024
I’ve had this actually happen with Roasted Red Oak and this Mahogany piece. It seems to always seal the first side nicely then When I go over the other side, the shellac has small bubbles. I think this is caused by dried wood because it also happened with polyurethane brushed on. What is the technique for preventing this? Any way to recover the piece? I’ve done this one like 4-5 times now. Scuff with a red scotch brite pad and thin layer of sealer. I’m thinking a flat razor to flatten it agai
3D Printed Fixtures - Gallery - Carbide 3D Community Site
3D Printed Fixtures - Gallery - Carbide 3D Community Site
3D Printed Fixtures - Gallery - Carbide 3D Community Site
SO Pro Build, Enclosure, Setup, and Initial Carvings - Shapeoko
Struggling with wooden Inlays - Shapeoko - Carbide 3D Community Site
Beginner: I need advice - How To - Carbide 3D Community Site
Nails Magazine October 2011 by Bobit Business Media - Issuu
Wood surface has lots of white bubbles/spots after applying second
Wood surface has lots of white bubbles/spots after applying second
Beginner: I need advice - How To - Carbide 3D Community Site
Shellac bubbles when drying - Finishing - Carbide 3D Community Site
3D Printed Fixtures - Gallery - Carbide 3D Community Site
SO3: XXL Mega-Enclosure and Dust Collection - Shapeoko - Carbide
SO Pro Build, Enclosure, Setup, and Initial Carvings - Shapeoko
Recommended for you
You may also like