High Temp Waterproof DS18B20 Digital temperature sensor + extras : ID 642 : $14.95 : Adafruit Industries, Unique & fun DIY electronics and kits

Adafruit Industries, Unique & fun DIY electronics and kits High Temp Waterproof DS18B20 Digital temperature sensor + extras : ID 642 - This is a pre-wired and waterproofed version of the DS18B20 sensor made with a PTFE wire cable. Handy for when you need to measure something far away, or in wet conditions. This sensor is a little more expensive than the other waterproof version we have with a PVC cable because
This is a pre-wired and waterproofed version of the DS18B20 sensor made with a PTFE wire cable. Handy for when you need to measure something far away, or in wet conditions. This sensor is a little more expensive than the other waterproof version we have with a PVC cable because this one can be used up to 125°C - the limit of the sensor itself. That said, it's still not recommended for salt-water or corrosive environments since the stainless steel will eventually rust!Because the sensor signal is digital, you don't get any signal degradation even over long distances! These 1-wire digital temperature sensors are fairly precise (±0.5°C over much of the range) and can give up to 12 bits of precision from the onboard digital-to-analog converter. They work great with any microcontroller using a single digital pin, and you can even connect multiple ones to the same pin, each one has a unique 64-bit ID burned in at the factory to differentiate them. Usable with 3.0-5.0V systems.The only downside is they use the Dallas 1-Wire protocol, which is somewhat complex, and requires a bunch of code to parse out the communication. If you want something really simple, and you have an analog input pin, the TMP36 is trivial to get going.We toss in a 4.7k resistor, which is required as a pullup from the DATA to VCC line when using the sensor. We don't have a detailed tutorial up yet but you can get started by using the Dallas Temperature Control Arduino library which requires also the OneWire Library.

Description Usable with 3.0V to 5.5V power/data Stainless steel tube 6mm diameter by 35mm long ±0.5°C Accuracy from -10°C to +85°C Uses 1-Wire

DS18B20 Waterproof Digital Temperature Sensor Kit

Adafruit Thermocouple Amplifier with 1-Wire Breakout Board - Max31850k, White

Power supply range: 3.0v to 5.5v Output lead:red (VCC), yellow(DATA) , black(GND) length:Approx.100 cm No other components, unique single bus

Gikfun DS18B20 Temperature Sensor Waterproof Digital Thermal Probe Sensor for Arduino (Pack of 5pcs) EK1083

High Temp Waterproof DS18B20 Digital Temperature Sensor [3m long

Temperature Sensor - Waterproof (DS18B20) - SEN-11050 - SparkFun

DS18B20 Waterproof Digital Temperature Sensor Kit - RobotShop

DS18B20 Temperature Sensor Module Stainless Steel Temperature

Waterproof SMD DS18B20 Digital Temperature Sensor - RobotShop

High Temp Waterproof DS18B20 Digital temperature sensor + extras

Temperature Sensor Module Kit: Pull-up resistor included on the adapter module, connect directly to the GPIO of the Raspberry Pi. DS18B20 TO-92

2 Pack DS18B20 Temperature Sensor Module Kit with Waterproof Stainless Steel Probe, TO-92 for Arduino and Raspberry Pi

Gikfun DS18B20 Waterproof Digital Temperature Sensor with Adapter

Temperature Sensor - Waterproof (DS18B20) - SEN-11050 - SparkFun

DS18B20 Temperature Sensor Module Kit with Waterproof Stainless