Hobbylinc Extra Fine Extender Tips (6) -- Glue Tip Glue Applicator

Hobbylinc Extra Cyanoacrylate Tops -- CA Glue Tip Glue Applicator

Iron Modeler: The Plastic Addiction

High strength, rapid setting, epoxy formulated to set hard, clear and sandable, and tolerate mixing ratio errors. Each bottle has a 3witches hat2 free-flowing nozzle with matching over-cap.

Deluxe Materials LTD Ad65 Speed Epoxy II - 4-Minute Set Time -- 7-9/16oz 224g

PL01 and PL02 are pen type cement. It is the limonene type, so it has no irritating smell of solvent and you can use it without worrying about being a nuisance to others.There is a standard type pen nib and extra thin type. Use them according to the parts you want to bond.

Mr Hobby Pl01 Mr. Cement Limonene Pen Standard Tip

Super-Gold Thin 2oz Odorless

Bob Smith Industries INSTA-SET CA (super glue) Accelerator. INSTA-SET is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization. INSTA-SET in a spray bottle is normally used to cure the CA that flows from joints when parts are pressed together. Applying an additional bead of thick CA along a seam and then curing it with INSTA-SET significantly enhances a joint’s strength.

Bob Smith Insta-Set Accelerator 2 oz.

Hobbylinc INSTA-CURE Gap Filling Cyanoacrylate 2oz Hobby CA Super Glue #108

This accessory pack contains all the component parts for mounting one or two 24 mm D and E engines in BT-55, 60 and 80 body tubes. Included are:30052 - Large Diameter Laser Cut Centering Ring (qty. 1)This BT-80 body tube centering ring set is laser cut from heavy duty cardstock and allows the model rocket builder the option to insert a single 4 in., BT-50 motor tube into a much larger diameter body tube.30132 - Small Diameter Laser Cut Centering Ring (qty.

Estes D and E Engine Mount Kit

Insta-Cure has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together while you apply the CA around the edges of the seam. At the moment CAs cure, they give off a vapor that can irritate the nose and eyes, so be prepared. Thin CAs work very well on balsa since they penetrate into the wood and form more than just a surface bond. Unscrew top from nozzle.

Insta-Cure Super Thin CA Glue 1 oz.

The v2 Glue Looper is a patented micro fluid applicator made for applying a VERY small amount of glue where you want it to go, with little to no trace visible. Apply the smallest amount of glue exactly where you want it! Designed to use with any hobby knife handle. 10 loops. 4 small, 4 medium and 2 large.For thin viscosity glues.Cleans easily. Burn off glue residue with a lighter.

Creative Dynamic The Glue Looper

Removable Tip For Glue – Lovely US

Flex-I-File Touch-N-Flow Applicator Hobby and Model Glue Applicator #711

Bob-Smith Ic-2000 Black RubberiZed 1oz #118

Super Glue Applicator Tips

The TRANSROC - a Retro Model Rocket Telemetry Transmitter : 20 Steps (with Pictures) - Instructables