Easy Heat RS-2 Roof Cable Deicing Control

The EasyHeat Freeze Free Connection Plug provides a fast, reliable and economical method of connecting the Freeze Free cable to a standard 120 VAC receptacle. Each plug is supplied with an end seal, reliable and easy to install. Installation tape, thermostats and pipe insulation are available accessories. Freeze Free cable can be connected directly to the power supply without requirement for thermostat control.

Easy Heat 10802 Freeze Free Connection Kit

RKF-ADKS - Easy Heat RKF-ADKS - Roof & Gutter Deicing Cable Assortment w/ RS2 Control

Easy Heat RS-2 Automatic Roof De-Icing Cable Control : Home & Kitchen

Easyheat RS-2 Roof Sentry Automatic Roof De-icing Cable 1200w 120v-ac

Control expense and energy use in electric roof cable protection automatically with Roof Sentry RS-2. The RS-2 requires two conditions to be present before it energizes roof deicing cable cold temperatures ON, 38-degree F OFF, 48-degree F and the presence of runoff water from the roof in contact with its sensor wire. If only one of the conditions exists, the control will not energize the cable.

Easy Heat RS-2 Automatic Roof De-Icing Cable Control

EasyHeat ADKS Flashing Bender for Residential Roof and Gutter De-Icing - 120 ft, 5 lbs, 5W/ft Heating Power in the Roofing Tools & Accessories department at

Heat tape (cable) control - Device Ideas - SmartThings Community

Easy Heat DSH Downspout Hanger Kit

Thermostats for Roof Cable Kits Frost King® Weatherization Products

Control expense and energy use in electric roof cable protection automatically with Roof Sentry RS-2. The RS-2 requires two conditions to be present before it energizes roof deicing cable cold temperatures ON, 38-degree F OFF, 48-degree F and the presence of runoff water from the roof in contact with its sensor wire. If only one of the conditions exists, the control will not energize the cable.

Easy Heat RS-2 Automatic Roof De-Icing Cable Control

EasyHeat Freeze Free Pipe Heat Cable Connection Kit and Controller

The EasyHeat roof sentry RS2 unit automatically controls operation of ADKS electric roof de-icing cable. It measures both temperature and moisture to turn the system on or off in response to changing weather conditions. Controller requires two conditions to be present before it will energize the roof de-icing cable. It requires cold temperatures and the presence of run-off water from the roof in contact with the sensor wire.

Easy Heat RS2 Roof Sentry De-Icing Control