EVA (2mm) brick walls - Beyond the Manual - Glowforge Owners Forum

Hello all. I make miniatures and one of the biggest pains in the butt is making brick textures. In the past, I would usually draw lines onto foam board with a dull pencil to simulate the look of brick (then texture the foam with a foil ball). On my last diorama, I decided to try cutting the brick pattern into EVA foam. This worked well for the scale I was doing - 1:24. I think the mortar lines would be too big for smaller scales, due to the size of the kerf, but I haven’t experimented yet.

Letter from the Editor: Spring 2013 – Juris Magazine

Verve. November 2023. Issue 203. by Verve Magazine - Issuu

Glowforge is a great piece of machinery, however - Lounge - Dangerous Things Forum

EVA (2mm) brick walls - Beyond the Manual - Glowforge Owners Forum

Australian artist – Art Blart _ art and cultural memory archive

Furniture & Joinery Production #348 by Gearing Media Group Ltd - Issuu

Can brick be engraved / marked? - Beyond the Manual - Glowforge Owners Forum

Best New Gear and Coolest Gadgets This Week, According to Men's Journal - Men's Journal

Jigging Master Fishing Rod Rubber Gimbal Bottom Cap (Type: A), MORE, Fishing, Rods - Airsoft Superstore

Glowforge is a great piece of machinery, however - Lounge - Dangerous Things Forum

Building a modular zoetrope - Made on a Glowforge - Glowforge Owners Forum

Control panel material? - Beyond the Manual - Glowforge Owners Forum

Grainline patterns Susan Young Sewing

EVA (2mm) brick walls - Beyond the Manual - Glowforge Owners Forum

Joint Sealants WBDG - Whole Building Design Guide