17 DEGREE Folding Cone, DELRIN, 1/4″ inch to 3/4″ inch Hole Sizes Folding Range – Legacy Brand Coin Ring Tools

Universal 17 degree folding cone machined from Delrin. Use this tool with any brand of coin ring reduction dies to fold coins with holes from 1/4″ inch (0.25″) to 3/4″ inch (0.75&…
Universal 17 degree folding cone machined from Delrin. Use this tool with any brand of coin ring reduction dies to fold coins with holes from 1/4 inch (0.25) to 3/4 inch (0.75). This is a direct replica of our popular stainless steel cone made from detail protecting Delrin plastic. Use this Delrin folding cone to help preserve the inner detail of coins when folding. Punched holes should be deburred and free of sharp edges before using your Delrin folding cone. For coins that are not 99% silver, it's important to remember that Delrin cones should not be your primary folding cone. Ringers should use a steel cone for the majority of the fold and then transition to the delrin cone for the last little bit where you would get the most metal to metal contact. And remember to always anneal your coins during the folding process. Use in your hydraulic press or arbor press. Not for use in ring sizing machines, due to tool height and the lack of clearance.

Delrin Folding Cone Set - Used for making coin rings

Products – Legacy Brand Coin Ring Tools

, We have been getting customer requests for a simple and inexpensive, entry level tool set to get started with coin ring making. This is that

Beginners Coin Ring Tool Bundle (Punch and spacer set, 3 double sided dies and a folding cone)

Sanding Cone

One Universal Folding/Reduction Die .9″ x 1.0″ @ 17 degrees – Coin

17 Degrees Stainless Steel Folding Cone Set (1/4, 1/2, 5/8, 3/4

17 Degree Five Piece Set of Folding/Reduction Dies and Stainless

Coin Hole Punch

Arbor Press Ram Head New Design for Coin Ring Makers - Israel

17 Degree Folding SET cone dies coin ring tool fold over quarter

Delrin Folding Cone Set - Used for making coin rings

17 Folding Die

Ring Making Tools

1 Inch Cones