1/2 Bowl Gouge - Bottom Feeder, Bowl Gouges

All 1/2" Bowl Gouge - Bottom Feeder flutes are individually inspected and hand polished to remove all machine marks. This extra step assures the sharpest cutting edge possible. They are shipped sharp. The Bottom Feeder grind is used on the inside of bowls especialy for finish cuts, I also use it on the outside of bowls from the foot to the top for all of my finishing cuts, if you learn to use this grind for finish cuts your sanding will be greatly reduced. You can always sand a piece into submission, but it is not much fun.

WoodRiver - Bowl Gouge 1/2

Shipped sharp with the grind found at Mahoney’s lathe Superior M42 high speed steel with a 10% cobalt content, for unparalleled edge holding Unmatched

Carter and Son Toolworks - Mike Mahoney Signature Bowl Gouges

I am excited to announce my new line of bowl gouges! Here are the specs: • True 1/2” diameter • Parabolic flute with rounded top edges • M2 Steel •

Ashley Harwood 1/2 Push Cut Bowl Gouge w/ Bolster — Ashley Harwood Woodturning - Turning Native LLC

Shipped sharp with the grind found at Mahoney’s lathe, Superior M42 high speed steel with a 10% cobalt content, for unparalleled edge

Carter and Son Toolworks - Mike Mahoney Signature Bowl Gouges

Bottom Bowl Gouge? American Association of Woodturners

1/2 Bowl Gouge Wood Lathe Turning Tool

Carter and Son Toolworks - Mike Mahoney Signature Bowl Gouges - Spiracraft

This Masterflute Bowl Gouge is made with a parabolic flute shape and has the end gound at the factory in a Side Grind, sometimes called a Celtic

Packard 1/2 Masterflute Side Grind Bowl Gouge

Henry Taylor Mike Mahoney Signature Bottom Feeder, Hand Tools